Influence of Al3+ doping for V5+ on the structural,optical, thermal and electrical properties of V2-xAlxO5-δ (x=0–0.20) ceramics

This paper reports an investigation on the structure-properties correlation of trivalent metal oxide (Al₂O₃)-doped V₂O₅ ceramics synthesized by the melt-quench technique. XRD patterns confirmed a single orthorhombic V₂O₅ phase formation with increasing strain on the doping of Al₂O₃ in place of V₂O₅ in the samples estimated by Williamson-Hall analysis. FTIR and Raman investigations revealed a structural change as [VO₅] polyhedra converts into [VO₄] polyhedra on the doping of Al₂O₃ into V₂O₅. The optical band gap was found in a wide semiconductor range as confirmed by UV–visible spectroscopy analysis. The thermal and conductivity behavior of the prepared samples were studied using thermal gravimetric analysis (TGA) and impedance analyzer, respectively. All the prepared ceramics exhibit good DC conductivity (0.22–0.36 Sm^-1) at 400 ?C. These materials can be considered for intermediate temperature solid oxide fuel cell (IT-SOFC)/battery applications due to their good conductivity and good thermal stability.     

浅谈电子电工技术在电力系统中的应用

本文针对电子电工技术在电力系统中的作用进行了分析,同时为该技术的推广提出了相应的建议。     

Magnetic porous nano-carbon catalysts supported silver nanoparticles derived from chitin and their application in catalytic reduction reactions

The exploitation of recycled carbonaceous catalysts from renewable biomass resources such as chitin is a crucial issue for the development of the sustainable society. In this article, the chitin-based N and O doped carbon microspheres (ChC) were fabricated by a simple dissolution, sol–gel transformation, and the carbonization methods. Subsequently, the novel magnetic Ag-Fe₃O₄@chitin-based carbon microspheres catalyst (MChC) was successfully constructed through the in situ redox reaction. The as-prepared MChC possessed rich micropores with high-surface area, and a narrow size distribution (50–120 μm). The Ag-Fe₃O₄ nanoparticles were immobilized through the interaction with C, N, and O atoms in the pores of MChC. The reduction of 4-nitrophenol was applied to evaluate the catalytic activity of MChC. 4-Nitrophenol (4-NP) could be fully reduced to 4-aminophenol (4-AP) in 5 min with the catalyst MChC-45. Moreover, MChC could be collected in solution with an external magnet in 8 s and remained relatively high-catalytic activity after 10 cycle times. This work provided novel ideas for the fabrication of doped carbon material from biomass and promoted its utilization in nanocatalytic applications.     

Influence of surfactants on rheological behaviors of polyacrylonitrile/dimethyl sulfoxide/silicon blending polymer solutions

KH550, KH560, CTAB, and F127 were adopted to modify silicon (Si) to improve the dispersity and stability of Si in the polyacrylonitrile/dimethyl sulfoxide (PAN/DMSO) polymer solutions. The influence of surfactants on rheological behaviors of PAN/DMSO/Si blending polymer solutions was investigated by an advanced solution and melt rotation rheometer. The homogeneity and stability were also studied. The results showed that the surfactants could change the viscosity dependence of blending polymer solutions on shear rate, temperature and storage time by increase the steric hindrance of Si. Among the four solutions, PAN/DMSO/Si blending polymer solution with F127 exhibited the lowest viscosity, activation energy and the smallest structural viscosity index and exhibited the trend close to the Newtonian fluids. Moreover, PAN/DMSO/Si blending polymer solution with F127 exhibited the best dispersity and stability, indicating its best physical properties and machinability.     

Evolution of the electrical resistivity at rest and during oscillatory shearing of co-continuous morphology (PP/PMMA)/MWCNT systems

In this work, a modified parallel-disks configuration on a strain-controlled ARES rheometer (TA Instrument) was used to study the evolution of the electrical resistivity at rest and during oscillatory shearing of a co-continuous immiscible polymer blend morphology based on polypropylene and /polymethyl(methacrylate) (PP/PMMA) in which various amounts (0–3 wt%) of multiwall carbon nanotubes (MWCNT) were added. The co-continuity of both PP and PMMA phases allowed the buildup of a conductive network due to the preferential localization of the conductive MWCNT at the interface between PP and PMMA. Under a stepwise increase of the oscillatory strain amplitude below a critical value (γ_c = 6.3%), a significant decrease in the electrical resistivity was observed for MWCNT concentrations above the percolation threshold (0.3 wt%) due to the conductive paths induced by both thermal (Brownian) motion and oscillatory shearing. However, for deformation amplitudes higher than γ_c, the resistivity increased due to the destruction of the MWCNT paths induced by the large deformation imposed on the PP/PMMA interface. These observations were also confirmed by the evolution of the storage modulus (G′) which remained constant for γ_c < 6.3% (linear viscoelastic regime), while the values decreased above γ_c due to the destruction of the system's morphology.     

Combinations of Piperine with Hydroxypropyl-β-Cyclodextrin as a Multifunctional System

Piperine is an alkaloid that has extensive pharmacological activity and impacts other active substances bioavailability due to inhibition of CYP450 enzymes, stimulation of amino acid transporters and P-glycoprotein inhibition. Low solubility and the associated low bioavailability of piperine limit its potential. The combination of piperine with 2-hydroxypropyl-β-cyclodextrin (HP-β-CD) causes a significant increase in its solubility and, consequently, an increase in permeability through gastrointestinal tract membranes and the blood–brain barrier. X-ray powder diffraction (XRPD), differential scanning calorimetry (DSC), Fourier-transform infrared spectroscopy (FT-IR), nuclear magnetic resonance (NMR) were used to characterize interactions between piperine and HP-β-CD. The observed physicochemical changes should be combined with the process of piperine and CD system formation. Importantly, with an increase in solubility and permeability of piperine as a result of interaction with CD, it was proven to maintain its biological activity concerning the antioxidant potential (2,2-diphenyl-1-picryl-hydrazyl-hydrate assay), inhibition of enzymes essential for the inflammatory process and for neurodegenerative changes (hyaluronidase, acetylcholinesterase, butyrylcholinesterase).     

武汉市一般人群血清中全氟及多氟烷基化合物浓度及其影响因素研究

目的 了解武汉市一般人群血清中全氟及多氟烷基化合物(PFASs)浓度,探索血清中PFASs浓度水平的影响因素。方法 以在武汉市某医院进行一般体检的人群为研究对象(n=67),通过超高效液相色谱-三重四级杆质谱(UPLC-TQ/MS)联用仪测定外周血清中12种PFASs浓度,采用多元线性回归分析方法分析一般人口学特征和血清中PFASs浓度的关联性。结果 武汉市一般人群血清中12种PFASs的平均浓度水平为11.60 ng/mL。全氟辛烷磺酸及其盐类(PFOS)和全氟辛酸及其盐类(PFOA)的贡献率较大,分别为45.03%和31.86%。男性人群血清中PFOS、PFOA、全氟己基磺酸(PFHxS)、全氟壬酸(PFNA)等主要化合物的浓度高于女性,其β值(95%可信区间)分别为0.708(0.313,1.104)、0.518(0.069,0.967)、0.724(0.388,1.059)和0.684(0.399,0.968)。同时,发现血清中PFOS、PFHxS、PFNA浓度和年龄呈正相关,其β值(95%可信区间)分别为0.062(0.042,0.081)、0.035(0.019,0.052)和0.030(0.016,0.045)。结论 性别和年龄对血清中PFASs浓度有影响,在进行人体PFASs暴露评估中应考虑这些因素。     

菌酶协同改善花生粕的饲用品质

花生粕是重要的蛋白饲料原料，但由于其氨基酸不平衡，特别是精氨酸与赖氨酸比例严重失衡（精氨酸与赖氨酸含量比值在3~4，理想的精氨酸与赖氨酸含量比值为1.0），限制了其在动物养殖中的应用。研究了复合酶预处理结合乳酸菌发酵花生粕对其品质的改善。结果表明：经菌酶协同处理后，花生粕粗蛋白质含量由46.4%提高至506%，大分子蛋白明显降解为小分子蛋白，酸溶蛋白质含量由2.3%提高至17.8%，多肽含量由1.6%提高至15.7%，蛋氨酸和赖氨酸含量分别提高了77.1%和42.0%，精氨酸降解率为18.7%，精氨酸与赖氨酸含量比值从3.7降低至2.1，总酸含量由06%提高到4.7%，其中乳酸含量由0.64 mg/g提高至14.63 mg/g。菌酶协同处理后的花生粕抗氧化性明显增强，其中每克菌酶协同处理后的花生粕对羟自由基的清除能力与171.6 mg VC相当，比花生粕（与47.6 mg VC相当）提高了2.6倍。     

WSN低功耗低时延路径式协同计算方法

针对云计算应用于无线传感器网络(Wireless Sensor Network,WSN)时延敏感型业务时存在的高传输时延问题,提出了一种WSN低功耗低时延路径式协同计算方法。该方法基于一种云雾网络架构开展研究,该架构利用汇聚节点组成雾计算层;在数据传输过程中基于雾计算层的计算能力分步骤完成任务计算,降低任务处理时延;由于汇聚节点计算能力较弱,时延降低将导致能耗增加,WSN工作寿命减短,为此提出能耗约束下的任务映射策略,并利用离散二进制粒子群优化(Binary Particle Swarm Optimization,BPSO)算法解决能耗约束下的时延优化问题。仿真结果表明,在相同的能耗约束下,对比其他算法,基于BPSO算法得出的映射方案能有效降低业务处理时延,满足时延敏感型业务的需求。